This equipment has been tested and found to comply with the limits for a Class B digjital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any intererence received, including interference that may cause undesired operation. This device complies with Part 15 of the FCC Rules, Subpart B, Unintentional Radiators. Such changes andlor modifications not expressly approved by the party responsible for compliance of this device could void the users authority to operate the equipmentįurther RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. Regulatory NoticesĬAUTION: The manufacturer is not responsible for any interference caused by unauthorized modifications andlor use of unauthorized antennas. Adjust your wireless LAN configuration based on your environment after installing the driver.
Installing the Drivers and UtilitiesĪfter the computer starts, install the driver for the Wi-Fi/Bluetooth Card. Step 4 Then move the antennas to a place where the signal is good.Step 3: Tighten the antenna cables to the antenna connectors on the Wi-Fi/Bluetooth card respectively.Step 2: Connect the other end of the USB cable to the F_USB connector on the motherboard.
Connect one end of the USB cable to the USB connector on the Wi-Fi/Bluetooth card.
0 kommentar(er)
